200W Adjustable DC Step Up Converter 635V to 655V Efficiency Power Boost Module for Electronics

200W Adjustable Step Up Converter Module A power DC boost converter for raising input voltages from 6V up to 35V to adjustable outputs between 6V and 55V. Designed with an aluminum shell for improved heat dissipation and screw terminal connections for simple wiring, this module delivers efficient, stable voltage boosting for a wide range of electronic equipment and projects. Key benefits power capacity: 200W maximum output for demanding loads and powerhungry devices. Wide input and output range: accept DC 6 to 35V input and set output anywhere from 6 to 55V to match device requirements. conversion efficiency: up to 97.6 percent measured at input 32V, output 45V at 3A. Actual efficiency depends on input and output voltages and current. Reliable thermal design: aluminum shell improves heat dissipation for more stable operation under load. Easy wiring and installation: screw terminal input and output for secure, toolfriendly connections. Compact footprint: measures approximately 70 x 39 x 32 mm for installation in tight spaces. Technical specifications Component materials: plastic and metal Module dimensions: approximately 70 x 39 x 32 mm 2.76 x 1.54 x 1.26 inch Input voltage range: DC 6 to 35V Output voltage range: DC 6 to 55V (boost only; output must be greater than or equal to input) Maximum input power: up to 200W. Maximum power is reached when input voltage is greater than 30V. Maximum input current: up to 10A. Allow margin for continuous operation. Maximum output current: up to 7A. Allow margin for continuous operation. Conversion efficiency: up to 97.6 percent measured at input 32V, output 45V at 3A. Efficiency varies with operating conditions. Connections: screw terminals for input and output. Typical use scenarios Mobile workstation power: boost a vehicle or battery voltage to supply laptops or peripherals when a specific higher rail is required. Remote network or telecom equipment: provide a steady boosted rail for routers, switches, or signal equipment in field installations where the available supply is lower than required. Bench testing and DIY projects: adjust output to custom voltages for component testing, prototyping, or powering LED drivers and motor controllers. Package contents 1 piece 200W step up module with aluminum shell Notes and cautions This is a boost converter only. Output voltage cannot be lower than input voltage. For long continuous operation, leave current margin below the listed maximums. Allow 1 to 2 cm tolerance for manual measurement of module size. Slight color differences may occur due to different display settings. Measured efficiency quoted under specific test conditions. Actual performance depends on input and output voltages and load current.