Technical Specifications: Four (4) extra strong N52 neodymium magnets Mounted on the cockpit, board or other flat surface With telescopic arm Material: ABS, aluminum, silicone rubber Mounting: suction cup Rotatable ball head and telescopic arm Easy to assemble and use Dimensions: diameter 45 mm Minimum arm length: 10 cm Maximum arm length: 23 cm Weight: 145g (186g whole set with packaging) Set contains: Magnetic holder with suction cup mounted on the cockpit, board or other flat surface 2 metal plates with double-sided adhesive tape (large rectangular and small round) Sticky gel suction cup Sticks to any smooth and flat surface firmly and without residue, reusable. a dirty suction cup loses its viscosity, wash the suction cup with soapy water, leave to air dry. Great versatility Strong suction cup mounted on the cockpit, board or other flat surface. Many adjustment options, and thus we can perfectly match the handle to your needs. Four neodymium magnets Four strong N52 neodymium magnets and a durable base ensure a stable position of the phone, even when driving on bumpy roads. The holder will hold the phone even through a cover or an additional case. The permanent magnetic field does not interfere with the phone signal and will not cause damage to the smartphone. Rotating (360) head The ability to set the phone at the required angle so that it is most suited to your needs. Increased protection Front and rear rubber pads with anti-slip and anti-scratch properties protect the phone and the vent from any damage. Quick to assemble and disassemble Installation and removal of the phone holder can be done with just one hand in just a few seconds. No tools are required. Ways to mount the plate to the phone: 1. Between the housing and the battery Remove the back cover of the phone, stick the metal plate, replace the back cover of the phone. The holder will hold the phone and the plate will not be visible. 2. Right on your phone If the phone does not have a removable back cover, attach the plate directly to the back of the phone. 3. Under the extra pouch Remove the case, stick the metal plate, put the case back on. The holder will hold the phone and the plate will not be visible. 4. Directly on the case Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.