[ALL-METAL GEARS]: High-temperature resistance, high abrasion resistance, strong load capacity, sturdy and , effectively protect the motor body. [PURE COPPER WIRE CORE ROTOR]: With precision winding technology, the geared motor power instant increased by 30%. [D SHAPED OUTPUT SHAFT]: Using high hardness steel, good toughness, impact resistance, the quality of the bearing and the service life of the gear motor are improved, extremely . [POSITIVE-NEGATIVE ROTATION]: You also can adjust the speed, but the motor speed can only be reduced, can not be raised. Low noise and high torque, such as 10rpm can drive 15 kilograms. Rated Voltage: DC 12V Reduction Ratio: 1:148 No-Load Speed: 30RPM Rated Torque: 12Kg.cm Rated Current: 0.92Amp D Shaped Output Shaft Size: 6x14mm (0.24inch x 0.55inch) (D*L) Size: 37 x 26.5mm (1.46inch x 1.04inch) (D*L) Motor Size: 36.2 x 33.3mm (1.43inch x 1.31inch) (D*L) Mounting Hole Size: M3 (not included) Application: Vending equipments, pan camera, slot machine, money detector, coin refund devices, automatic doors, peritoneal machine, toys motor etc. PLEASE NOTE: 1.Use tolerance: Pay attention to the use of voltage and current range, otherwise the motor performance and motor life decline. 2.Handling motors: Gently, as far as possible the use of motor shell part. 3.Motor wiring: Red lead to the positive electrode, black lead to the negative pole, if reversed, the motor rotation in the opposite direction. 4.Overload: As far as possible within the specified load range, prohibit motor blocking or close to the stall state for too long time to runs. Otherwise, the motor burn out. 5.Motor storage: Storage temperature: 0 Celsius - 40 Celsius Storage humidity: 15% -90% RH Avoid placing in high temperature, high humidity and gases Motor use temperature: 0 Celsius - 70 Celsius Colour: silver Material: metal Size: 36.2 x 33.3mm Package Contents: 1 * Gear Motor Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.