Features:1.This typewriter can make embossed adhesive labels and can print letters, numbers and symbols.2.The embossing manual typewriter is ergonomically designed, easy to use and modern in appearance.3.Easy to use, portable, no battery or power required, suitable for scrapbooks, photo albums, and DIY projects.4.Comes with adhesive and 9mm special adhesive tape. The adhesive tape comes with adhesive, which can be pasted on any glossy exterior after removing the adhesive.5.No ink, no need to charge, permanent use, stamping principle, invert the mold on the tape, and auto-forward 1-button type, cut 1-button type, convenient and quick disk changing.specification:Item Type: Embossing Manual TypewriterMaterial: ABSFunction: Suitable for scrapbooks, photo albums, DIY projectsSize: Approx. 11.5 x 5.6 x 2.2cm / 4.5 x 2.2 x 0.9in (manual measurement, for reference)Tape Length: Approx. 2meters / 6.6ftTape Width: Approx. 9mm / 0.4inInstructions:1. Insert the tape into the white pinion port, press the handle continuously, and roll the tape in (note: the handle is pressed with two ridges, half of it is a space, and the bottom is to print)2. Bring the tape to about the red line and start typing, the printed word is in the middle3. Turn the dial manually to find the word to be printed and press it firmly4. After printing, manually turn the dial to the scissors, and press it to the end to cut the tape5. Tear off the adhesive and stick it where you want to stick (the plane is firmer)Change Plate Steps:1. Turn to the back of the labeling machine and push the middle black button2. The middle snap button on the front can be pulled out3. Pull out the middle snap4. Take out the plate5. Put in the plate, install the button6. The change plate is completeLetter Plate Size: Approx. 5.6cm / 2.2in5.6cm / 2.2inPackageList:1 xPrinting Label Machine1 xLetter Plate1 xTapeNote1. There are 2 ridges when the handle is pressed, half of which is a space, and the bottom is pressed to print.2. This model uses concave?convex printing, that is, the principle of stamping. It will be clear when typing is pressed hard to the end. The cutting function is to cut off a small rectangle. The edge may not be ideal. You can trim it with scissors to be beautiful.3. Remove the remaining tape after disassembling the turntable and pull it out, which may cause damage to the tape.