The for Pico is a microcontroller board based on the for RP2040 microcontroller chip. It has been designed to be a low-cost, high-performance microcontroller board with flexible digital interfaces. The for Pico features two ARM -M0+ cores run up to 133MHz; 256KB RAM; 30 GPIO pins; and a broad range of interfacing options. This is paired with 2MB of onboard QSPI Flash memory for code and data storage. In addition to powerful , Pico has rich and complete software support and community resources. It comes with a complete Rasberry Pi official C/C++ , Micropython . Just clickhttps://pico.raspberrypi./-started/to get started with for Pico. Pico has been designed to use either soldered 0.1inch pin-headers (it is one 0.1inch pitch than a standard 40-pin DIP package) or can be used as a -mountable 'module', as the user IO pins are also castellated. There are SMT pads underneath the USB connector and BOOTSEL button RP2040 microcontroller chip designed by in the United Kingdom Dual-core Arm M0+ processor, flexible clock running up to 133 MHz 264KB of , and 2MB of on-board Flash memory Castellated module allows soldering direct to carrier boards USB 1.1 with device and host support Low-power sleep and dormant modes Drag-and-drop programming using mass storage over USB 26 x multi-function GPIO pins 2 x SPI, 2 x I2C, 2 x UART, 3 x 12-bit ADC, 16 x controllable PWM channels Accurate clock and timer on-chip Temperature sensor Accelerated floating-point libraries on-chip 8 x Programmable I/O (PIO) state machines for custom peripheral support Material:plastic colour:As Shown Package Contents: 1 x For Pico Kits Only the above package content, other products are not included. Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.