Ideal for making concrete driveway stones for gardens, streets, balconies and villas. Step 1: Mix cement with water, according to package directions. When ready to use, the concrete will be the consistency of oatmeal and thick enough to hold an edge when slicing with a shovel. Step 2: Fill mold with paver, scoop up the concrete with a shovel and be sure to fill each area. Step 3: Using rubber gloves, spread the concrete around the mold, filling in any gaps or low spots. Tap the mold with your hand to remove air bubbles. Step 4: Following the contours of the mold, smooth out the concrete, wiping off the excess. Step 5: let the concrete sit for a maximum of five minutes, then carefully remove the mold. For the next stretch, rotate the mold a quarter turn and place it next to the paver just finished, angle slightly if you are creating a curved path. Step 6: After leaving the concrete dry overnight, fill the cracks with dirt and remove any excess. Wet the ground around the newly formed pavers to help them settle. Features: Condition: New. Material: ABS. Colour: black. Dimensions: approximately 44.5 x 38.5 x 3.8 cm. Size after molding: 40 x 34 x 3.8 cm (approx). Contents: 1 cobblestone mould. Note: 1. Measurements are taken by hand, the sizes indicated may vary from 0 to 2.5 cm. Thank you for your understanding.