The moisture meter can quickly measure the moisture content of the grain. 1. DC to AC: This mains inverter is a device that converts the direct current of a solar panel into alternating current. Volume and capacity are small, capacity is from 0,2 to 1,6 kW. 2. 180V to 280V Output: This network microinverter supports DC input from 10,8V to 30V to AC output of 180V to 280V. 3. Aluminum Alloy: This solar microinverter is made of the highest quality aluminum alloy, which ensures a long lifespan. 4. Multiple Protection: This solar inverter has island protection, voltage protection, frequency protection, temperature protection, current protection, etc. 5. Specification: Item Type: Solar Network Inverter Material: Aluminum Alloy Inverter Box Size: Approx. 10 x 7,5 x 3,5 cm / 3,94 x 2,95 x 1,38 inches Output voltage waveform: sine wave Photovoltaic output (DC): Number of Input Connectors: 1 Set MPPT voltage range: 12,5 V to 25 V Operating voltage range: 10,8 V to 30 V Maximum input voltage: 30 V Initial Voltage: 10,8 V Maximum input power: 150 W Maximum Input Current: 9,37A AC Output (AC): Single Phase Network Type: 230V Rated Output Power: 130W Maximum output power: 140 W AC rated current: 230V: 0,56A Rated AC Voltage: 230V AC Output voltage range: 230V AC: 180V to 280V Rated AC Frequency:: 50/60Hz Output frequency range: 50 Hz: 47,5 to 52,5 Hz/60 Hz: 57,5 to 62,5 Hz Output power factor: andgt; 0,99 Efficiency: Highest conversion efficiency: 92,5% CEC weighted efficiency: 230V AC: 91,5% MPPT: Tracking performance: 99,9% Night loss: andlt; 700mW Temperature range: Minus 40 ℃ to 65 ℃ (ambient temperature)/minus 40 ℃ to 85 ℃ (storage temperature) Waterproof Class: IP55 Communication: None Protection mode: island protection, voltage protection, frequency protection, temperature protection, current protection, etc. Comprehensive grounding: The end of the PE AC cable is the grounding cable of the device and there is no other grounding port. List of packages: 1 x Solar Network Inverter 1 x instruction manual; 1 x AC Cable Note: This device can only be connected to solar photovoltaic modules as an input source. This device is a grid-connected power generation device, it must be connected to the power grid, and it can normally generate electricity only when the power grid is functioning properly. In the event of a power grid failure, the device will also stop generating electricity. Before use, make sure that the VOC open circuit voltage and the working voltage of the VMP photovoltaic module are compatible with the input voltage and operating voltage range of this device. ensure that the maximum output power of the photovoltaic modules does not exceed the maximum input power of the device. Please do not cover any other objects on this device, please do not open the housing, repair this device must be done by professionals When the photovoltaic modules are connected to this device and exposed to sunlight, they will power this equipment with direct current, please pay attention to safety. the device in a place where it can be exposed to direct sunlight or can be covered with rain and snow (e.g. gap) between two components should be avoided)