Function description: 1. Remote anti-theft Press the lock key of the remote control once, the direction indicator flashes once, and the horn sounds once to enter the anti-theft state. At this time, the vibration sensor works, and the motorcycle engine enters the flameout locking state, unable to start the vehicle. 2. Remote control release Press the Unlock button of the remote control once, the direction indicator flashes twice, and the horn sounds twice to remove the theft deterrent. Open the vehicle key manually to start the vehicle normally. 3. Silent anti-theft Press the Mute button of the remote control once, the turn signal will flash once, and the horn will sound once. Press the Mute button of the remote control again three seconds later, and the turn signal will flash once, but the horn will not sound, and the system will enter the silent anti-theft state. If the vibration alarm occurs, the direction indicator flashes and the horn does not sound. 4. Start the vehicle remotely Press the mute key of the remote control twice, and the motorcycle engine will start immediately. You can drive normally without manually opening the car key. During the remote start driving, press the Mute button of the remote control once to turn off the engine remotely. 5. Remote searching Press the Search key on the remote control for 2.5 seconds, the direction indicator flashes 5 times and the horn sounds 5 times to search for the car. Specifications Voltage: 12V ± 2V Static current: less than 15mA Frequency: 433.92MHz Code: learning code Distance: about 60-80m Remote control battery: CR2016 6V (excluding) Scope of application: applicable to all 12V motorcycles, suitable for AC starting models Matching of APP and remote control: Turn on the Motorcycle APP, and a prompt will appear. Turn on the Bluetooth switch of the mobile phone. A green dot on the Bluetooth icon on the interface indicates that Bluetooth has been turned on. Click the gear icon at the top right of the interface to enter the setting interface. Press the learn code key once, then press the remote control and two keys once at the same time, and then