Features: new and hight . Made of hardened steel Comes with 3 socket, M10 M12 ,M14 Material: steel Color: as shown Installation : First smear a thin layer of high temperature resistant butter on the of body, and then knock the into body along the outer ring. not to knock to the middle. After the is knocked to , a thick sound will be emitted. It's already in place. At this time, put a thin layer of butter on the inner ring of the , insert the crankshaft into the , and use a tool to tighten the nut from the other end while pulling it. When the crankshaft is about to be pulled into place, you should not use too much force. Then apply sealant on and pull the crankshaft into the other half of . After installation, the crankshaft is not in the middle of , and it rotates very tightly or does not rotate at all. At this time, you can use tools such as the eye or feeler gauge to determine which direction the crankshaft is offset, and then use this box tools to straighten the crankshaft. Pay attention to the grasp of the strength, not too hard to prevent the clearance from being enlarged. After the rotation is , the installation is complete and the oil seal can be applied. Each is equipped with M10, M12, M14, 3 heads. Suitable for models Package Contents: 1 x Crankshaft Installation Tool set Only the above package content, other are not included. Note: Light reflection and different displays may cause the color of the item in the a little different from the real thing. The measurement allowed error is +/- 1-3cm.