1. Latest ELM327 version for improved compatibility 2. Modified design includes a switch to connect to different CAN buses 3. Designed for use with FORScan software 4. Compatible with software vendors: FORScan, Elmconfig (supports Baud rate: 34800, please verify before ordering), FF2, and FoCCCus, among others Basic Features: Reset fault/trouble codes/parameter IDs (PIDs), change vehicle configuration data, run tests, perform service procedures Supports MS CAN bus and HS CAN bus ELM327 USB 25k80 with switch for diagnostic cable Product Introduction: This ELM327 OBDII OBD2 USB cable features a switch and is designed for communication with and vehicles. When used with compatible software, it can detect modules not accessible to standard OBD2 scanners. It enables viewing of trouble codes, PIDs, running tests, and performing service procedures that are not available through regular OBD2 scanners or standard ELM327 devices. Pin Configurations: Switch outside: HS CAN – uses pins 6 and 14 Switch inside: MS CAN – uses pins 3 and 11 Supported Software: FORScan Elmconfig (supports Baud rate: 34800, please verify before ordering) FoCCCus Modified ELM327 Information: Many and models from approximately 2003–2004 onward are equipped with an MS CAN bus in addition to the standard HS CAN bus. Unlike HS CAN, the MS CAN bus is not supported by standard ELM327 devices because it uses non-OBD2 designated pins and is manufacturer-specific. This device has been modified to support MS CAN bus communication. The ELM327 natively supports HS CAN as 's HS CAN complies with OBD2 standards, using pins 6 and 14. MS CAN uses pins 3 and 11. Color: As shown Material: ABS Package Contents: 1 x Diagnostic Scan Tool Note: Only the items listed above are included; other accessories are not included