Description
Three-electrode stainless steel probe compatible with liquid level controller (edition 1105)
Three Probe Stainless Steel Probe Sensor compatible with Water Liquid Level Controller Edition 1105
Usage Tips:
Three Probe Cables Stainless Steel Probe Induction Sensor compatible with Water Tank Liquid Level Controller
Feature:
1. Electrode type water level controller, using 304 stainless steel electrode pole, using plastic encapsulation to compatible withm an insulating sleeve, using anti-short circuit design, not because of the water tank or shaft wall damp conduction caused by misoperation.
2. The electrode water level sensor takes the conductivity of water as its working principle, and makes use of the conductivity of the water in the boiler.
3. When the water level in the boiler changes, the electric circuit is closed or disconnected because of the contact and separation between the electrode poles of different lengths and the water at different water levels, thus the signal reflecting the change of the water level is transmitted to the outside, and then according to this signal, the water level can be changed.
4. Function: receiving and transmitting the signal in the location of the water.
5. Application: Solar air tank, water pump, water supply pool, distribution pool, water treatment pool, well, water tank.
Specification:
Color: red, white, blue
Probe material: SUS304# stainless steel.
Length: red wire: 1.5 meters/4.9ft, white wire: 2.5 meters/8.2ft, blue wire: 3.5 meters/11.4ft.
Liquid level sensor: heat resistance 105
Product voltage: 250V-380V
Product current: maximum support 10A pass
Warm Tips:
1. The liquid level sensor must be placed in the water to measure the water level.
2. It is compatible withbidden to measure the sensor and the common pole short circuit directly.
3. When the standard liquid level sensor is not long enough, the user can extend the wiring by himself.
4. In order to avoid the controller failure, the extension wire should be shielded to prevent the interference of thunder damage.
Note:
Please allow 1-3cm differs due to manual measurement.
Due to the different display and different light, the picture may not show the actual color of the item. Thanks compatible with your understanding.
1 x Red Probe Induction Sensor
1 x White Probe Induction Sensor
1 x Blue Probe Induction Sensor
-
Fruugo ID:
496267232-1021216490
-
EAN:
9186491859523
Product Safety Information
Please see the product safety information specific to this product outlined below
The following information is provided by the independent third-party retailer selling this product.
Product Safety Labels
Safety Warnings:
Important Safety Instructions
Read Before Use: Please read all instructions and safety warnings before using this product. Failure to follow these guidelines may result in injury, damage, or malfunction.
General Warnings
Intended Use: Use this product only for its intended purpose as described in the user manual.
Supervision Required: This product is not intended for use by children or persons with reduced physical, sensory, or mental capabilities without supervision.
Inspection Before Use: Check for any signs of damage or wear before use. Do not use if damaged.
