Universal Garage Door Automatic Gate Remote Control Receiver Controller Switch Receiver 43392Mhz rolling code Transmitter Garage Door Gate Receiver For 99% of the 433mhz remote control in the market Item condition - New - GATE-RC Frequency - 433.92MHz. Operating voltage - 12V DC-24V DC AC CodesFixed / Learning / Rolling Code Transmit distance - 100m in open space. Open space means no any interference. No walls, no doors, no trees or any other obstructions. Interference like garage door or brick wall can reduce remote control range significantly. 1 receiver can store 200pcs of rolling code remote control receiver 1) Can learn Fixed and Rolling code 433,92Mhz remote controls separately and simultaneously !!! 2) Can learn and use most Original 433,92Mhz Fixed and Rolling code remote controls !!! ( Such as : BFT, V2 , DitecCAME, MOOVO, MHOUSE PUJOL, GIBIDI, DOORHAN, ATA PTX4, MARANTEC ) 3) 2 channel receiver provides you with an option to control and use 2 gate automations or alarm systems simultaneously 4) 1 relay can store 200 pcs remote control, the receiver can store 400 pcs remote control INSTALLATION: Position the receiver in a place adequately protected from atmospheric agents 1) Connect the wires coming from the power supply to the VDD+ and GND- terminals 2) Connect the wires coming from the device to the NO and CM terminals of the chosen channel Remote control transmitter Decoder IC - rolling code. Frequency - 433.92MHz. Operating voltage - 12V DC 23A (Free battery included) High safety factor chip, scrolling code, unable to be copied Ultra long transmission distance, To be used with our receiver, can reach a distance of 100 meters Please confirm that your original remote control is the same as our remote control 'Grey' If it is not the same remote control, it will not work Wide range of uses: Garage doors, Electronic gates, Barrier gates, sliding doors, automatic doors, rolling doors, shutters Electrical appliances/Home automation i.e. lights, Alarm system, access control system Sometimes you need more remote controls for your gate, alarm, fire alarm or any other system. To buy a few additional original remotes for your gate and alarm system is quite expensive. So this is the best and much cheaper solution for you!!! Easy to use: 1. Connect the two power supply wires, one to 12-24V and the other AC/DC 2. When the power is initiated the LED will light for 1 second and the receiver is ready for instructions. 3. LEARNING CODE: Press P1 for at least 1 second, the LED will light for 1 second, go off for 1 second and then light again, press any button on the remote, if the code is learnt the LED will blink, then release the button on the remote. If the remote cannot read the signal, the LED will light for 10 seconds and finish its learning status. 4. PROGRAMMING METHOD: A. Press P1 once, the LED flashes once and the first channel (monostable)activates. B. Press P1 twice, the LED flashes twice and the second channel (monostable)activates. C. Press P1 three times, the LED flashes three times and the first channel(bistable) activates. D. Press P1 four times, the LED flashes four times and the second channel(bistable) activates. The receiver can learn at least 200 codes. The receiver supports all codes including fixed and rolling codes. 5. DELETING FUNCTION: A. Deleting one code: Press P2 for approximately 3 seconds, the LED will light, press the button of the code you no longer require and the code will be deleted. B. Deleting all codes: Press P2 for 8 seconds or until the LED lights, release the button and the LED will go off, all codes will have been deleted. 6. NOTE: A. The data for rolling codes is relatively big and will take a little more time to operate the remote than would take with a fixed code. B. If the same code is entered more than once, only the last code is memorized. _x000D_